DLQD-DP202 Advanced Electro Pneumatic Training Equipment
The DLQD-DP202 advanced electro pneumatic training equipment is added with electronic control units on the basis of DLQD-DP101 pneumatic trainer. It uses a separate relay control unit and multiple buttons for electrical control. Users can also choose a PLC so as to further understand and master the PLC. The PLC can communicate with a PC to realize intelligent control.
Pneumatic basic experiment circuits illustrate:
- Single acting cylinder reversing circuit
- Double acting cylinder reversing circuit,
- Single acting cylinder speed control circuit,
- Double acting cylinder one-way speed regulation circuit,
- Speed changing-over circuit,
- Buffering circuit
- Twice pressure control circuit,
- High and low voltage convert circuit,
- Counting circuit,
- Delay circuit,
- Overload protection circuit,
- Interlocking circuit,
- Single cylinder single reciprocating control circuit,
- Single cylinder continuous reciprocating action circuit,
- Straight line cylinder , rotate cylinder sequence action circuit
Technical parameters
Optional (System)
- Power unit - air compressor (Basic configuration minicomputers)
- Power source: AC 220V±10% 50Hz/60Hz
- Motor power: 480W
- Nominal volume: 6L
- Rated output pressure: 0.85MPa
- Noise grade: 66dB
- Workbench
- Workbench size: 1360 X 650 X 1650mm
- Aluminum panel size: 1200 (L) X 600 (W)
- Teaching resources
- Pneumatic simulation software
- Valve terminal
- Step controller
- Lead frame
- Computer desk
- DLQD-CY1 Electro pneumatic machining, stamping training object
- DLQD-JXS1 Electric pneumatic manipulator training object